Check the Design Process page for more information
Version 1
Version 1 uses a sail and a float design. The main goals of this version were to limit the amount of plastic used and keep a low center of gravity.
Version 2
Version 2 reduces the amount of plastic needed without raising the center of gravity significantly.
Version 3
Version 3 was a complete redesign. It was designed to self-tecelate which would make a 'sheet' of them across the surface of the water.
Version 4
Version 4 refined the amount of plastic used
Version 4 Vacuum Forming Blank
This is a blank that would allow us to manufacture Version 4 in bulk through Vacuum Forming.
Version 5
Version 5 added a loft that would allow the units to more easily rotate.
Version 6
This iteration allowed the units to rotate more easily in the water and also reduced their ability to stack.
No comments:
Post a Comment